Fabric buckets

From vintagericrac.blogspot.com

For each bucket you will need:
· 5 ½ x 18 ½ inch strips of outer fabric, light wadding and iron–on interfacing.
· 6 x 18 ½ inch strip of lining fabric (note it is a bit bigger so you get the nice trim at the top.
· Circles measuring 6 inches across in outer, wadding, interfacing and lining for the base.

Step 1.

• 
  You may do this differently but I prefer to iron my interfacing to my wadding rather than my fabric – I hate those little wrinkles I always get if I iron onto the fabric.
  Do the same for the bucket bottoms as well.

Step 2.

With outer fabric and lining right sides together (and the wadding interfaced piece under the outer fabric) sew along the long (18 1/2 inch) edge that will be the top of the bucket.

You can see the layers here. The black is the lining (face down) linen is the outer (face up) and then the wadding/interfacing on the back of the linen.

Open up and press the seam.

Step 3.

Take the short (5 1/2 inch) sides together and sew along creating a tube. Almost done now –

Step 4.

Sew the bottom into the outer fabric end right sides together. I do this by dividing the circle and the outer into fourths and than matching up the pins. You can clip this seam after you have sewn it if you like. Do the same at the other end with the lining base BUT leave a turning space (I leave about 1/4 of the circle).

(the brown is the lining in this photo)

Step 5.

Turn the whole bucket back through the space you left in the bottom. Then you simply tuck your lining into your bucket and slip stitch the opening closed. I like to top stitch around the top.

You can stitch-in-the-ditch for a nice finish.